How to turn on the radio and select a band, Tuning
Radio mode select button
Band select button
~
Tuning button
How to turn on the radio and select a band
1. Press the Radio mode select button (
B)
to turn on the radio.
2. Adjust the volume and tone quality. (See page 8 “Audio
conrol”.)
3. Pressing the Band select button (
m),
select the desired band.
With each press, the band shifts as follows.
FM1
+FM2-AM
Tuning
. . . . . . . . . . . . . . .
There are 2 types as follows.
I”8
*n
,b,,@&~,,
:_
+
,**)
I
&*3
i
J”,,
P
**
*>
“,1.
~1
,:
. . . . . . The unit will tune up or down in frequency and stop on
the next strong station. (The tuning normally operates in
the auto mode.)
Press the (
44
) or (
w
) side of the Tuning button (
..sEEK.+
).
0
To tune
up
Press the (
w
) side for less than 0.7 seconds.
To tune down
Press the (
+
) side for less than 0.7 seconds.
w
~~~:~~,~~~~~~tlso~~~:~~~~~
. . . . . . With each press, the frequency will shift up or down by
50
kHz
(FM) or 9
kHz
(AM).
1. Press and hold the (
ti
) or (
w
) side of the Tuning button (
..sEEKH
) for 0.7
sec-
0
onds or more to switch to the manual tuning mode. The frequency indicator will
flash on and off.
Note:
It
returns to Auto (Seek) tuning mode if the Tuning button is not pressed within 5
seconds after it becomes Manual tuning mode.
2. Press the (
4+
) or (
w
) side of the Tuning button (
..IEEKH
) when the frequency
indicator flashes on and off.
0
*I
Hint:
l
Press and hold the button to change the frequency quickly.
14
To Next Page
Loading...
