Error and Status indications
The following Error or Status indications may be displayed while operating the unit or
CD Changer.
_
Indication 1
Cause Remedv
-
E:Ol
Abnormal disc change function
Contact your place of purchase.
(CD Changer only)
E:07
The disc is inserted upsidedown.
Take out the disc and insert it with
label side facing up.
The disc is dirty.
Clean the disc.
E:30
Excessive temperature in this unit
Allow the car and
/
or the CD
or CD Changer is detected.
Changer location to cool. The indi-
cation disappears when the tem-
perature decreases.
---
Magazine is not fully inserted into
Completely insert the magazine
the CD Changer.
into the changer
until1
it clicks in
(CD Changer only)
place.
000
There are no discs in the maga- Insert the discs into the magazine.
zine. (CD Changer only)
2
--
There is not a disc in the slot No. 2 The indication disappears when
of magazine.
you insert a disc into the slot No.%
(CD Changer only)
Before Wiring and Installation
General
%
l
This unit is designed to be operated on + 12 volt DC negative ground electrical
2
systems. The unit cannot be operated on + 24 volt or positive ground electrical sys-
$’
terns.
g
3
l
According to this manual, wire and install the unit. If you are not confident in your
ability to install the unit correctly, have it installed by a proffesional mobile electron-
&
its
installation technician.
$
l
Remove a transport screw and make all electrical
5
connections before installing the unit.
$L-Transport
screw
5
I
2
D3
2
5
2
a,
=
%.
0
3
20
To Next Page
Loading...
