Notes:
l
The Fader control will have no effect on the output when using a two speaker
installation. Under this condition, set the Fader control to the
‘V’position.
l
When not using a Power antenna, cover the end of the Power antenna control wire
(Blue) with electrical tape, to prevent it from shorting to the unit or the vehicle chassis.
How to connect CD Changer(s)
The CDF-R800 has a built-in CD Changer controller. You can upgrade your vehicle
system by adding of up to two compatible SANYO CD Changers.
Note:
When connecting the CD Changer(s), read the manuals of the CD Changer(s) and
the Divider unit as well as this manual.
Connect the end of DIN cable (8 pin), which is supplied with the SANYO CD Chang-
er, to the CD Changer DIN socket of CDF-R800, and connect the other end to the CD
Changer.
Note:
The ID Switch of CD changer should be set to
“1”position
CDF-RBOO
DIN Antenna plug
A separately available SANYO Divider unit (FTP-CH1 S) is necessary to connect two
CD Changers. As to the details, follow the manual of Divider unit.
Note:
Set the ID Switches of CD changers to “1” or ‘2” position respectively.
CDF-R800
See page 22.
DIN Antenna plug
II
DIN
Cable(8pin)
DIN
Cable(8pin)
23
To Next Page
Loading...
