13
Dynamic bass boost system (DBBS)
Set the DBBS switch to ON to enhance the bass sound.
Auto power on function
The power turns on automatically when i button is pressed.
Auto power off function
The power turns off automatically after about 60 seconds when all tracks on a disc have
been played or when the n button is pressed once to stop play.
Hold function (Fig. 5)
The HOLD switch disables the buttons from operating to prevent play from starting or
stopping due to accidental operation. For normal use, leave the switch in the off position.
To prevent battery drain:
Set the HOLD switch to the on position when carrying the unit in a bag. The i button
will not function even if the button is pressed accidentally. “HOLD” appears briefly on the
display.
To prevent play from being interrupted:
Set the HOLD switch to the on position after starting play. “HOLD” appears briefly.
If the operating buttons do not function when pressed ...
1. Check whether the HOLD switch is on or not.
2. Remove the batteries and/or disconnect the AC adaptor from the unit. Wait a few
seconds, then reinstall the batteries or reconnect the AC adaptor.
3. If the buttons still do not function, insert new batteries.
CDP-M420_XE 16/04/2004, 12:0613
To Next Page
Loading...
