19
Programmed Playback [MP3 CD]
1. Press the PROG button during stop.
2. Press the skip button to select a folder number.
3. Press the PROG button. The folder number remains.
Press the skip button to select a track.
4. Press the PROG button. It is programmed.
5. Repeat steps 2 to 4 to programme track.
6. Follow the same procedure as steps 5 to 6 in the “programmed playback [Music
CD]”.
Changing a programme
To add a new track to a programme:
1. In the stop mode, press the PROG button repeatedly until appears.
2. Select a track as explained above.
3. Press the PROG button.
To change a track:
1. In the stop mode, press the PROG button repeatedly until the track number to be
replaced is displayed.
2. Select a track as explained above.
3. Press the PROG button.
Note:
• Programmed details cannot be partially deleted or inserted.
• The programmes will be lost after turn off the power or the disc compartment is
opened.
CDP-M420_XE 16/04/2004, 12:0619
To Next Page
Loading...
