- 2 -
1. FM
Connection
Input Output
Alignment voltage IC211 Alignment voltage IC211
3-22pin(TP24,25) is 0.0±0.05V 3-22pin is 0.0±0.05V
--- Connect Digital DC voltmeter to 87.5MHz
L2002
1.00±0.05V
--- TP11(H), TP12(E). 108.0MHz --- 5.30±0.50V Check Only
TP13(L), TP14(R), 90.0MHz ---
TP15(E)
106.0MHz ---
2. AM
Connection
Input Output
Connect Sweep generator to test
point TP13(L), TP14(R) and TP15(E).
--- Connect Digital DC voltmeter to 522kHz
L2205
1.00±0.05V
--- TP11(H )and TP12(E). 1710kHz --- 7.50±0.50V Check Only
Connect to VTVM 603kHz L2204
point TP13(L), TP14(R) and TP15(E).
1404kHz CT211
FM Antenna Maximum
Maximum
98.0MHz
Cover
Voltage
450kHz
at 999kHz
T2001
MaximumLoop Ant
SG
Frequency
Cover
Voltage
Tracking
3
FM Antenna SG=66dBuV
IF
Adjustment
Loop Ant
1
2
1
Tracking
2
IF(0V)
Adjustment
Step
Step
Adjusting
Circuit
Adjusting
Circuit
3
Remark
Remark
SG
Frequency
Adjustment
Adjustment
T2002
TUNER ADJUSTMENTS
E
MW ANT
E
E
E
T002A 94V-0
E
E
E
E
VT
L2205
XF212
IC201
XF211
CT211
Q2001
D2005
D2004
D2102
SH201
D2002D2003
C2009
J2126
L2003
J2210
C2104
J2209
C2111
C2119
C2121
C2801
C2701
C2106
C2113
C2107
D2101
L2005
Q2101
L2006
J2203
J2206
J2119
C2312
C2108
Q2111
J2308
C2218
Q2201
J2115
J2205
S2001
J2208
CN201
L2002
1AD4B10D2411D
J2305
J2116
J2117
C2112
T2002
IC211
T2001
J2124
U
J2121
L2204
J2307
L2007
Q2002
D2104
CN203
Q2102
J2301
Q2110
J2202
XF215
J2302
R2129
CN202
J2118
J2111
J2125
J2113
J2303
J2120
J2304
J2306
CN204
XF210
J2114
D2105
J2123
Q2003
J2122
J2204
J2207
J2201
J2112
J2127
D2006
L2001
C2131
C2142
R2131
C2024C2005
C2002
R2001
C2001
C2902
C2120
R2107
L2002 L2205
L2204
TP11
TP24TP25
TP12
TP13
TP14
TP15
T2001
CT211
IC211
T2002
Antenna : 75Ω unbalanced direct, Modulation : 1 kHz
Dev. : ±22.5kHz(MONO), ±22.5kHz(MAIN), ±6.75kHz(PILOT)
RF Level : dBuV EMF
Output Level : about 30mV at TP13, TP14, TP15
Anntena : IRE Loop(SG), Moduration : 1kHz 30%
RF Level : dBuV EMF
Output Level : about 30mV at TP13, TP14, TP15
CD PICK-UP MAINTENANCE
About pick-up (Optical lens) Cleaning
Clean a lens with swab of the cotton which moistened it with alcohol, cleaning paper or cleaning disc appointed.
Specified cleaning disc : LC-1 (Part code : 645 026 1961 ..... manufactured by SANYO.)
Show a clean procedure in the following in reference by swab of cotton.
1. Cotton swab is wrapped with Cleaning paper.
2. Add the isopropyl alcohol.
3. Gently move the tip of cotton swab just like a draw a whirlpool from inside to outside on the surface of lens.
• Use a plastic screw driver for adjustments.
• MODE : ST (Stereo)
• Speaker impedance : 4 ohms
• TUNING
FM : 87.5 - 108MHz
AM : 522 - 1710kHz(9 step)
520 - 1710kHz(10kHz step)