EasyManua.ls Logo

Sanyo DC-F300 - TAPE DUBBING (Deck A to Deck B); Dubbing Methods

Sanyo DC-F300
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TAPE D.UBBING.,.(g
n
-Iai
.,-,...... ,,,”........
,. ...,
Load the cassette to be played back into deck A and a blank cassette into
deck B.
Computer dubbing
-
Use the same length
dubbing operation.
cassettes in both decks for the computer
1. Select ‘TAPE function.
2. Press the HIGH or NORMAL COMPUTER REC button.
HIGH: For high speed dubbing. “HI SPEED” appears on the display.
For dubbing the tape at high speed (twice normal speed).
NORMAL For normal speed dubbing. “HI SPEED disappears.
For dubbing while monitoring at normal speed,
The system performs the steps below and automatically star% deck
A playback and deck B recording.
1) Deck A: Tape rewinds.
2) Deck B: Tape rewinds.
3) Deck B: Erases the first few seconds of the tape.
“A-b dlJb”, “A”, “W, “COMpL1. REC”, >”, (“HI SPEED”) and “REC”
appear on the display as dubbing begins.
When the end of the tape has been reached on deck B, both decks
stop automatically.
3. Turn over both cassettes and reinsefi them.
4. Press the HIGH or NORMAL COMpUTER REC button to dub side B
of deck A.
Press the button to stop dubbing at any time. The tape will not stop
during computer dubbing if the REC PAUSE button is pressed.
During high-speed dubbing, normal monitoring iS not possible.
Computer dubbing must start from the beginning of the tape. To start
dubbing from a position in the middle of the tape, use manual dubbing.
K&nual dubbing
1.
Select “TAPE” function.
2- Select”=” reverse mode.
3. Deck B: Locate the tape position where recording will begin.
4. Deck A: In the forward direction, 10Cafethe selection of the tape to be
dubbed.
5. Press the REC PAUSE button. “REC” and “B” appear, and “E” blinks
on the display.
6. Press the button. “A” appears and” remains lit. Manual dubbing
starts.
Deck A playback will start in the forward direction.
7. Press the E button to stop dubbing.
Au$orr?atic stop during tape dubbing
If deck A or deck B stops automatically, the other deck will also stop.
During tape dubbing, the DOLBY NR button has no effect on the
copied tape. If the tape to be copied is encoded with Dolby NR, the
copy will be Dolby NR encoded automatically.
15

Related product manuals