PRECAUTIO
v--
,.
w
If water should enter the uni~ electrical shock or malfunction may
result. Always use it in a place where there is low humidity and little
dust.
Do not use where there are e~emes of temperature (below 5CC or
exceeding 35”C) or where dirad sunlight may strike it.
Because of the CD player’s extremely low noise and wide dynamic
range, there might be a tendency to set the volume on the amplifier
unnecessarily high. Doing so may produce an excessively large
output from the amplifier which could damage your speakers.
Sudden changes in the ambient~mperature may cause condensation
to form on the optical lens inside the unit. If this happens, take out the
disc, leave the unit for about 1 hour, and then proceed to operate.
- When carrying the unit, be sufe to remove any discs which may
be inside and turn the power off. The STANDBY indicator lights.
Then unplug the mains lead from the AC outlet. Carrying the unit
with any discs inside may dswnage the discs ancf/or the unit.
The system’s speakers use powerful magnets. Do not place timepieces,
credit cards, cassette tapes or video tapes, etc. near the speakers.
Before use
Remove the shipping screw from the rear of the unit as shown in figure.
This screw is used to secure the CD mechanism during shipment and
should be retained for future use es shown in figure.
Shipping screw
Green arrow
Before transportation
1.
Turn on the power and remove all discs from the unit.
2. Turn the power off. The STANDBY indicator I@%.
3. Then unplug the mains lead from the AC outlet.
4. Reinstall the shipping screw as shown in figure.
IMPORTANT
If thw plug supplied with this equipment is not suitable for the socket
outiids in your home it should be cut off and replaced with the correct
type.
Dfsgposal of Plug
If tf%e non rewireable plug is to be cut off, the removed plug should be
disposed of carefully as there is a shock hazard should the plug be
insawted into a live socket.
Rep4acing Fuse
Thr%detachable fuse cover must be replaced after changing the fuse.
Or@v a 3A fuse should be used and should comply with 6S1362 and
shwld carry the ASTA mark @.
The wires in the mains lead are coloured in accordance with the
folfmwing code;
Blue
Neutral
Brown
Live
The wires in the mains lead must be connected to the terminals in the
plmg as follows;
Wire co[our
Plug terminal marking
Blue
N or Black or Blue
Brown L or Red or Brown
W not connect either wire to the earth terminal.
Mtie mains plug contains a fuse this should be 3A, if a plug without a
fuse is used the distribution board fuse should not be greater than 5A.
Thre unit is not d=onnected from the mains unless it is unplugged from
the AC outlet.
>
D@ not install tt’rki equipment in a confined space, such as a book case
orr built in cabinet.
2
To Next Page
Loading...
