>.
‘%!@?
AM loop
aerial
‘ ;
1 ‘
Q
1,
External
aerial
Aerial wire
d
I
I
k
Output [ I Earth
OR
leads lead
1P, i
I/j
lb ,
u
k’
0-
IJ’I
R ch speaker
L ch speaker
7
-J 1—-----,
I SANYO HT-F451J Surround processor I
\
L~
To an AC outlet
Amplified superwoofer
The system is not completel
disconnected from the main
when the U /ON button on th{
remote control is set to the ~
(standby) position.
Note:
Aerials (For UK)
Do not connect the -ins lead to an AC outlet until all connections
have been made.
In areas close to a transmitter the simple indoor aerial is sufficient to
receive broadcasts. Extend the aerial wire as strai~ht as ~ossible and,
When the unit is first connected, the display switches automatically to
the demonstration mode. To cancel this mode, turn the power on or
press the DISPLAY fw$tton.
Speakers
When connecting the speakers, make sure that (+) and (–) polarities are
matched properly. Otherwise, the sound may appear to be lacking in the
bass range and in stabitilfy.
Connect the speaker ti with the stripe to the red terminal (+) and the
other wire to the black k?crninal (-).
Note:
If desired, the speaker grilles can be removed.
while listening to the sound from the system, secure~t in a Position which
yields minimal distortion and noise.
In fringe areas or where reception is distorfed or noisy, an external aerial
(fIOt supplied) should be connected instead of the simple indoor aerial.
Consult your dealer.
FM aerial (For AU)
The FM indoor aerial is sufficient to receive most local FM broadcasts and
shoutd be connected to the FM 75 ohm terminal. Extend the aerial wire as
straight as possible and, while listening to the sound from the system,
secure it in a position which yields minimal distortion and noise.
In fringe areas or where reception is distorted or noisy, an FM external
aerial (not supplied) should be connected instead of the indoor aerial. The
terminals will accept 75-ohm coaxial cable. Consult your dealer.
To Next Page
Loading...
