I
q
AM @p
aerial
FM external
‘ ‘7
Q
aerial
FM aerial wire
m rl
Video equipment
Audio
outputs
[? —
~
----- -
..-
.
,*
IEii!l
o!
,.
‘et
l“.’
-----
m
I*I I lu-
C 0000000
.J!J 1’
I
J
SANYO HT-F450 Surround processor
R ch speaker
L ch speaker
ILL
Amplified superwoofer
To an AC outlet
AM loop aerial
o
\
Assemble the loop aerial as shown in
‘\
figure.
Unwind the aerial wires, then connect
#’
/
~Q
&
them to the AM LOOP ANT. terminals. @
r@~:\
l\\
/ ,>;
0 $,,~ 1
\\\
\-=..._//./, /
=—-
Place the loop aerial in a position which
yields the best AM (MW/LW) reception,
or attach it to a wall or other surface as
shown in figure.
Note:
To minimize noise, the speaker, mains
and any other leads should not come
close to the indoor or external aerial lead
and AM loop aerial. Do not place the
aerial leads close to the system.
Screws (not supplied)
Turntable or video equipment
For UK:
Connect the output leads and earth lead of a turntable (MM type) to the
VKDEO/PHONO IN sockets and GND terminal of the unit respectively. Set
the VIDEO/PHONO select switch to PHONO.
Or connect audio leads (not supplied) from the audio output sockets of a
video equipment to the VIDEO/PHONO IN sockets. Set the VIDEO/
Pi+OFJO select switch to VIDEO.
For AU:
Cmuwct audio leads (not supplied) from the audio output sockets of a
video equipment to the VIDEO IN sockets.
I-ksacfphones
Commect stereo headphones (not supplied) to the PHONES socket for
mo~ring or for private listening. The speakers are automatically
disconnected when headphones are connected.
Super woofer
Connect an amplified superwoofer(not supplied) to the SUPER WOOFER
socket.
4
i
To Next Page
Loading...
