EasyManuals Logo

Sanyo DC-MP9500 User Manual

Sanyo DC-MP9500
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
-1-
CAUTION
R SK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: R SQUE DE CHOC
É
LECTRIQUE NE PAS OVRIR
CLASS 1 LASER PRODUCT
LUOKAN 1 LASERLAITE
KLASS 1 LASERAPPARAT
CAUTION
THIS PRODUCT CONTAINS A LOW POWER LASER DEVICE. TO
ENSURE CONTINUED SAFETY DO NOT REMOVE ANY COVERS
OR
ATTEMPT
TO
GAIN
ACCESS
TO THE INSIDE OF THE PROD-
UCT. REFER ALL SERVICING TO QUALIFIED PERSONNEL.
- The apparatus shall not be exposed to dripping or splashing.
- Do not use where there are extremes of temperature (below 5
o
C or
exceeding 35
o
C), or where direct sunlight may strike it.
- Because of the CD player’s extremely low noise and wide dynamic
range, there might be a tendency to set the volume on the amplifier
unnecessarily high. Doing so may produce an excessively large out-
put from the amplifier which could damage your speakers.
- Sudden changes in the ambient temperature may cause condensa-
tion to form on the optical lens inside the unit. If this happens, take out
the disc, leave the unit for about 1 hour, and then proceed to operate.
- The system’s speakers use powerful magnets. Do not place time-
pieces, credit cards, cassette tapes or video tapes, etc. near the speak-
ers.
- Do not install this equipment in a confined space, such as a book
case or built in cabinet.
- No object filled with liquids, such as vase, shall be placed on the ap-
paratus.
- The rating label is located on the bottom of the unit.
IMPORTANT
If the plug supplied with this equipment is not suitable for the socket
outlets in your home it should be cut off and replaced with the correct
type.
Disposal of Plug
If the non rewireable plug is to be cut off, the removed plug should be
disposed of carefully as there is a shock hazard should the plug be
inserted into a live socket.
Replacing Fuse
The detachable fuse cover must be replaced after changing the fuse.
Only a 3A fuse should be used and should comply with BS1362 and
should carry the ASTA mark
.
The unit is not disconnected from the mains unless it is unplugged from the AC outlet.
The wires in the mains lead are coloured in accordance with the follow-
ing code:
Blue Neutral
Brown Live
The wires in the mains lead must be connected to the terminals in the
plug as follows:
Wire colour Plug terminal marking
Blue N or Black or Blue
Brown L or Red or Brown
Do not connect either wire to the earth terminal.
If the mains plug contains a fuse this should be 3A, if a plug without a
fuse is used the distribution board fuse should not be greater than 5A.
PRECAUTIONS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo DC-MP9500 and is the answer not in the manual?

Sanyo DC-MP9500 Specifications

General IconGeneral
BrandSanyo
ModelDC-MP9500
CategoryStereo System
LanguageEnglish

Related product manuals