Sanyo DSR-3000 Service Manual

− 5 −
Compact Flash Slot :
PC Card Slot :
RS-232C terminal :
•RS-485 terminal :
•Remote Control treminal :
•Alarm in treminal :
•Alarm out treminal :
•Alarm reset treminal :
•SW out treminal :
•NON Rec out treminal :
•Clock Adjust in treminal :
•Clock Adjust out treminal :
•Warning out treminal :
•Disk Full out treminal :
•Alarm Full out treminal :
Power :
Power consumption :
Operating environment :
Dimension :
Weight :
Compact Flash Type 2 (Front)
PCMCI Type 2 (Rear) for SCSI or Ethemet card
D-SUB 9pin (for PC)
Push lock (3 terminals: A, B, C (GND))
1 input for resister alley switch
1 input (Normal Open Low level active)
1 output (Normal 5V Low level active)
1 input (Normal Open Low level active)
1 output (Normal 5V Low level active)
1 output (Normal 5V Low level active)
1 input (Normal Open Low level active)
1 output (Normal 5V Low level active)
1 output (Normal 5V Low level active)
1 output (Normal 5V Low level active)
1 output (Normal 5V Low level active)
AC 120 V, 60 Hz (DSR-3000) ; AC 220 - 240 V, 50 Hz (DSR-3000P)
26 W 400mA (DSR-3000) ; 27 W 260mA (DSR-3000P)
Temperature: 5 °C to 40 °C, Humidity:10% to 80 %
420 (W) x 86 (H) x 364.5 (D) mm
Approx. 5.5 kg
Control connectors

Sanyo DSR-3000 Specifications

General

Brand	Sanyo
Model	DSR-3000
Category	DVR
Language	English