Sanyo DSR-3716PA - Page 5

Network Connection Procedure
4 English
3
Right click the settings of the LAN card being
used (Ethernet adapter) and the select
[Properties] from the menu.
The [General] tab of [Local Area Connection
Properties] will display.
4
Select [Internet Protocol (TCP/IP)] from the list
of [This connection uses the following items].
Confirm that [Internet Protocol (TCP/IP)] is checked. If
it is not checked, add a check mark.
5
Click [Properties].
The [General] tab of [Internet Protocol (TCP/IP)
properties] will display.
6
Select [Use the following IP address] and then
enter an IP address and subnet mask.
7
Confirm the setting contents and click [OK].
This ends the TCP/IP settings. Close all displayed
dialog boxes.