Sanyo dvw6100 - Deck Mechanism Disassembly

5-2
DECK MECHANISM DISASSEMBLY
1.Holder Clamp (Fig. 5-1)
1) Release 2 Screws(S1).
2) Unhook 2 Locking Tabs(L1).
3) Lift up the Holder Clamp and then separate it from the
Base Main.
1-1. Clamp Assembly Disc
1) Place the Clamp Assembly Disc as Fig. (A)
2) Lift up the Clamp Assembly Disc in direction of
arrow(A).
3) Separate the Clamp Assembly Disc from the Holder
Clamp.
1-1-1. Plate Clamp
1) Turn the Plate Clamp to counterclockwise direction and
then lift up the Plate Clamp.
1-1-2. Magnet Clamp
1-1-3. Clamp Upper
2. Tray Disc (Fig. 5-2)
1) Insert and push a Driver in the emergency eject
hole(A) at the right side, or put the Driver on the
Lever(B) of the Gear Emergency and pull the Lever(B)
in direction of arrow so that the Tray Disc is ejected
about 15~20mm.
2) Pull the Tray Disc until it is separated from the Base
Main completely.
(S1)
(L1)
(Fig. A)
(A)
CLAMP HOLDER
DISC CLAMP ASSEMBLY
MAIN BASE
CLAMP HOLDER
PLATE CLAMP
MAGNET CLAMP
UPPER CLAMP
(L1)
CLAMP HOLDER
(S1)
(B)
DISC TRAY
EMERGENCY EJECT HOLE
LEVER
MAIN BASE
MAIN BASE
BOTTOM SIDE VIEW
(A)
Fig. 5-1 Fig. 5-2