AUDIO OUT
S-VIDEO OUT
COAXIAL
COMPONENT VIEDO OUT
VIDEO OUT
Pr
Y
L
Pb
R
-E13-
Connecting to an Amplifier with Dolby Pro Logic Decoder (Example 6)
To AUDIO INPUT jacks
Note:
Please refer to your amplifier instruction manual.
*Please consult your local audio/video dealer.
Power Supply
Connect the power cord to a 120VAC 60Hz outlet. This unit is
equipped with a polarized plug. If you have difficulty inserting
the plug, turn it over and reinsert it. If the unit will not be used
for a long time, disconnect the AC plug from the AC outlet.
Notes:
• Before connecting the power cord to an AC outlet, make
sure that all the connections have been made.
• The unit cannot be entirely disconnected from the AC
power until the power cord is unplugged from the AC outlet.
• Do not damage the power cord.
• When not in use, disconnect the power cord from the
outlet. Grasp the plug, not the cord, when disconnecting
the unit.
• If water should enter the unit, electrical shock or a mal-
function may result. Use in an area where there is low
humidity and little dust.
• Do not disassemble or alter the unit in any way.
• Do not use the unit in areas where extremes in tempera-
ture occur (below 40˚F (5˚C) or exceeding 95˚F (35˚C)),
or where it may be exposed to direct sunlight.
• Because of the DVD video player extremely low noise
and wide dynamic range, there is a tendency to set the
volume on the amplifier higher than necessary. Doing so
may produce an excessively high output from the ampli-
fier which can cause damage to your speakers. Please
be careful in this regard.
• Sudden changes in the surrounding temperature can
cause dew to form on the optical pickup lens inside the
unit. Under this condition the unit may be unable to oper-
ate properly. If this should occur, remove the disc and
allow the unit to adjust to the surrounding temperature.
FOR SAFE AND EFFICIENT OPERATION
• When carrying the unit, be sure to remove a disc which
may be inside and turn the power off. Then unplug
the power cord from the AC outlet after 10 seconds.
Carrying the unit with a disc inside may damage the
disc and/or the unit.
• The unit is automatically set to the Screen Saver mode
after approximately 5 minutes have elapsed under the stop
or pause mode.
• The unit is automatically set to the standby mode after
approximately 30 minutes have elapsed under the com-
plete stop mode.
• Do not install this equipment in a confined space, such as
a book case or built in cabinet.
Press [q] (or [ q OPEN/CLOSE] on the remote control)
when closing the disc tray. Do not push the disc tray.
CAUTION:
When connecting the DVD video player, follow the instal-
lation instruction in “IMPORTANT SAFETY INSTRUC-
TIONS” on page E2.
Amplifier with Dolby Pro Logic Decoder
Surround right
speaker
Subwoofer
Front right
speaker
Surround left
speaker
Front left
speaker
Center
speaker
To AUDIO OUT jacks
*Audio cable
(not supplied)
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION :
POUR ÉVITER LES CHOC ÉLECTRIQUES‚
INTRODUIRE LA LAME LA PLUS LARGE DE LA
FICHE DANS LA BORNE CORRESPONDANTE DE
LA PRISE ET POUSSER JUSQU’ AU FOND.
DWM-450-US - English 3/16/05, 3:58 PM14
To Next Page
Loading...
