§
Amount tendered & Cash key
[%+]
%+
key
(%
mode)
Index the amount tendered by the customer
via
This key following entry
is
used to register a
this key. The register automatically displays the
manual percentage mark up.
A
correct change and opens the cash drawer.
If
this Without previous entry this key is used to
(
key
is
depressed without any previous entry, the calculate and register a mark-up according
to
transaction
is
finalized and a receipt
is
issued.
preset percentage.
~
Department key
~
%-key
(%mode)
Index an amount first, then depress appropriate This key following entry
is
used to register a
department key for itemizing. In tax mode each manual percentage discount.
department key may be set individually for Without previous entry this key is used for
[o~n
taxable or non-taxable status. Also department 2 discount calculation according
to
preset percent-
can be programmed
as
a discount department.
age.
Entry digit limit and single-item/non single-item
can be programmed
by
department.
GiJ
Half
pence key (U.K. mode)
Used to enter a half pence.
~
Tax shift key (Tax mode)
This key, followed by a department key, causes
[!]
Paper feed key
a temporary shift from a preset taxable depart-
Used to feed the tape forward.
ment
to
a non-taxable department or
vice
versa.
Depressing this key immediately before a tender-
ing
key makes a transaction exempt from a tax.
RECEIPT
Journal/Receipt selection
[~~9]
Manual tax & Taxable subtotal key (Tax mode)
OFF~
ON
switch
By
turning this switch on, the
This key after amount entries
is
used to register
tape
is
automatically fed
to
(
a manual tax.
In
this case the preset tax will be
the cutting position.
cancelled.
Without a previous entry this key is used
to
obtain a taxable subtotal.
-5
To Next Page
Loading...