Sanyo ECR-238 - Page 43

Reassembly
Step
Names of Parts
Inner paper guide
@ Paper feeding roller
@ Paper feeding shaft
spring
@ Paper feeding shaft
holder
@ Paper feeding gear
SP (61.5x6) x1
R-1 (2.3) x1
Points of Assembly Work
<POINT IN DISASSEMBLY >
@
To
remove
the
outer
paper
guide
ass‘y,
rotate
it
in
the
@
arrow
(b)
direction
indicated
in
the
preceding
figure.
@
Set
the
inner
paper
guide
onto
pin
D
in
the
frame
unit,
then
press
it
in
the
&®
arrow
direction
to
secure
its
upper
flat
segment
onto
pin
E.
Inner paper guide
Flat segment
Frame unit
Outer paper guide assy
@ After assembling parts @ to ©, mount the subassembly onto the frame
unit as follows.
@ Mount parts © to @ on the grooveed side of the paper feeding shaft.
@ After pressing SP onto the shaft, fit SP securely into the groove in the
paper feeding gear.
@ After parts @ to@® are assembled, mount this subassembly into the frame
unit.
@ Fit one end of the paper feeding shaft spring into the groove in frame
T and the other end into the groove on the inner paper guide.
@ Mount the paper feeding shaft holder from the inside of frame T, then
tighten R-1.
<CHECK>
@ The paper feeding rolier should rotate smoothly.
@ Press the paper feeding roller shaft several times in the arrow direction
to check that it slides lightly.
Inner paper guide Paper feeding shaft holder
Frame T
Paper feeding
shaft spring
Paper feeding shaft