Sanyo FWBP706F - Manual

EN 46
6. Use [
] to select “Next”, then press [OK].
Setup
WPA-PSK
Exit
Network
Language
Streaming Co...
Security
System
Previous
Next
**********
7. “Connection success and IP is obtained.” will be displayed. Press [OK] to complete the Settings.
NoteD
• The Internal Wireless LAN supports following specifications.
- Wireless standards: IEEE 802.11 b/g/n
- Frequency: 2.4 GHz
- Security protocol: WEP* / WPA / WPA2
* “WEP” is not recommended to be used due to its “Major security fl aws”. Change the Security protocol on
the Wireless Router to “WPA” or “WPA2 (recommended)” mode.
Manual
Set up the connection to the Wireless Router manually by entering the SSID.
In the following cases, select “Manual” to set each setting as necessary.
- When connection test failed with the setting of “Scan”.
1. Follow steps 1 to 5 in “Auto” on page 44.
2. Use [
] to select “Manual”, and use [ ] to select “Next”, then press [OK].
3. Use [
] to select the SSID entry fi eld, then press [OK]. The Software Keyboard will appear.
4. Use [
] and [OK] to enter the SSID. After entering the SSID, select “Enter”, then press [OK].
5. Use [
] to select “Next”, then press [OK].
6. Security Mode selection screen will appear. Use [
] to select the desired Security Mode, then press
[OK].
• If you select “None”, please go to step 10.
Language
Streaming Co...
Security
System
Network
None
WEP
WPA2-PSK(AES)
WPA/WPA2-PSK(AUTO)
Please select the Security Mode
Previous Next
Setup
continued on next page