Sanyo FWBP706F - HDMI Video Resolution

EN 49
11.3. HDMI Video Resolution
HOME A “Setup” A “ ” A “TV” A “Resolution”
Sets the Resolution of the Video Signal Output from the HDMI OUT jack.
C Set up Resolution
1. Use [ ] to select “Setup”in the Home Menu, then press [OK].
2. Use [
] to select “ ”, then press [OK].
3. Use [
] to select “TV”, then press [OK].
4. Use [
] to select “Resolution”, then press [OK].
5. Use [
] to select your desired Setting, then press [OK]. On the confi rmation screen, use [ ] to
select “OK”, then press [OK].
6. Press [HOME] to Exit.
C Set up HDMI 1080p/24 Hz
1. Follow steps 1 to 3 in “Set up Resolution” above on this page.
2. Use [
] to select “HDMI 1080p 24Hz”, then press [OK].
3. Use [
] to select “On” or “Off”, then press [OK].
4. Press [HOME] to Exit.
You can select the desired “Resolution” among the settings listed below: “Auto”, “480p”, “720p”, “1080i”, “1080p”.
Actual Output Resolution:
Setting in
“Resolution”
Setting in
“HDMI 1080p 24Hz”
Source
480i/60 480p/60 720p/60 1080i/60 1080p/60 1080p/24*
Auto
On
The highest resolution supported by your display device will automatically
be in effect.
* Images will be output in 1080p/24 when the connected device supports
1080p/24.
Off
The highest resolution supported by your display device will automatically
be in effect.
* Images will be output in 1080p/60 even if the connected device
supports 1080p/24.
480p
On
480p/60
Off
720p
On
720p/60
Off
1080i
On
1080i/60
Off
1080p
On
1080p/60
* Images will be output in 1080p/24 when the connected device supports
1080p/24.
Off
1080p/60
* Images will be output in 1080p/60 even if the connected device
supports 1080p/24.
continued on next page