Sanyo FWDP175F - Audio Settings; Audio Output Mode Configuration

–
19
–
EN
C
Audio Setting
Choose the appropriate Audio Settings for your device. It only affects the Sound during DVD Playback. Follow steps 1 and 2 on
page 16.
3 Select the desired item.
ENTER
SYSTEM
LANGUAGE
AUDIO
VIDEO
OTHER
Audio Out Bitstream
Dynamic Range PCM
<AUDIO menu>
4
Audio Out: (Default: Bitstream)
Set to “Bitstream” when the unit is connected to a Dolby
Digital decoder.
– Bitstream: outputs a Dolby Digital signals.
– PCM: convert the Dolby Digital into PCM (2 channel).
5 To Exit the Menu
Audio Out Bitstream
Dynamic Range PCM
Select the Desired
Setting.
Dynamic Range (Default: 0)
Adjusts for Clarity even when the Volume is Low, by
Compressing the Range of the lowest sound level and the
highest sound level.
Audio Out ·8
Dynamic Range
·6
·4
·2
·0
Note(s):
Audio Out:
– Bitstream:
Connecting to a Dolby Digital decoder for Dolby Digital Audio output.
The multi-channel audio signals are output from HDMI OUT jack with Bitstream or LPCM.
– PCM:
Connecting to another device (an MD deck or DAT deck etc.) without a Dolby Digital Decoder.
Convert the Dolby Digital into LPCM (2 channel).
•This unit does not support DTS audio. This is not a malfunction.
Youneedtosetthisunitto“Bitstream”inthe“AudioOut“MenuandalsoneedtoConnecttoaTVorAmplierthatsupports
DTS, then the audio will be output as DTS.
It is only available when connected via an HDMI cable.