Sanyo FXD-680GD - ELECTRICAL CONNECTIONS; Wiring Diagram and Safety; Power and Ground Wiring

ELECTRICAL CONNECTIONS
WIRING
Power Antenna/Amplifier Turn On (Blue/Red)
(WHITE/BLACK)
(GRAY/BLACK)
(VIOLET/BLACK)
(GREEN/BLACK)
Telephone Mute (Pink)
+12V Constant Power Supply (Yellow)
Ground Wire (Black)
+12V Accessory/Switch (Red)
Antenna Socket
4-SPEAKER SYSTEM 2-SPEAKER SYSTEM
(GREEN/BLACK)
(VIOLET/BLACK)
(GRAY/BLACK)
(WHITE/BLACK)
(VIOLET)
(GRAY)
(WHITE)
(GREEN)
Speaker
Rear Left
Speaker
Speaker
Rear Right
Front Left
Speaker
Front Right
(VIOLET)
(GRAY)
++
-
-
++
--
(WHITE)
(GREEN)
++
--
+
+
--
Front Right
Speaker
Front Left
Rear Right
Speaker
Speaker
Rear Left
Speaker
+
-
+
-
++
--
++
--
+
+
--
Part A
Part B
2 486
1
2
1
3
4
57
6
8
375
FUSE (15A)
N.C.
LINE OUT Cable (Gray)
AUX IN Cable (Black)
Part C
N.C. N.C.
Lch White
Lch White
Rch Red
Rch Red
CAUTION
• DO NOT connect any speaker wires to the metal body or chassis of the
vehicle.
• DO NOT connect the speaker common (–) wires to each other.
• Connect each speaker wire directly to each speaker terminal.
• All speaker common (–) wires must remain floating.
1 Antenna Socket
• Insert the plug from the antenna installed in your vehicle into this socket. (If your vehicle has a
dual antenna system, a dual antenna to single antenna cable adaptor may be required.)
2 + 12V Constant Power Supply (Yellow)
• Connect this wire to the +12V power terminal which receives power continuously.
3 +12V Accessory/Switched (Red)
• Connect this wire to the terminal which receives power while the ignition switch is ON or in the
ACCESSORY position.
18