Sanyo FXD-680GD - GENERAL OPERATION; Powering On;Off and Volume Control; Sound Adjustment and Modes; Clock Setting

GENERAL OPERATION
FM/MW/LW CD RECEIVER 45W x 4 CD-R&RW
2
1
3
7
54
9
86
TURNING THE POWER ON........................Any button
Install the front panel and press any button (except REL and EJECT button) when ACC is on.
TURNING THE POWER OFF .....................................................…...... 1
When system is on, press the POWER button 1 to turn off the unit.
VOLUME LEVEL CONTROL.......................................2
Rotate the VOL dial 2 to adjust the volume level.
ADJUSTING THE SOUND
CHARACTERISTICS ..................................….........2, 3
Press the AUDIO button 3:
1. Each time you press the AUDIO button 3, the item changes as follows;
VOL BAS TRB BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
2. Rotate the VOL dial 2 to adjust the selected item. Make the adjustment within 5 seconds after
selecting. After 5 seconds, the display window will revert to display priority.
Adjustment Range
BASS (BAS 00)
BAS –10 BAS 10
TREBLE (TRB 00) TRB –10 TRB 10
BALANCE (BAL L=R) 10L 10R
FADER (FAD F=R) 10F
10R
MODE SELECTION...................................……..….....4
Press SOURCE button 4 to choose desired listening mode. (e.g. radio mode to CD mode.)
SET THE CLOCK……………...............................5,8,9
Press the DISP button 5, the clock is shown on the LCD display. Then hold down the button until
the clock flashes. Then press the TUN/TRK
button 8 to change hours or TUN/TRK button
9 to change minutes.
6