Sanyo FXD-680GD - RADIO OPERATION; Switching to Radio and Band Selection; Radio Tuning Methods; Station Memory and Scanning

RADIO OPERATION
SEL
FM/MW/LW CD RECEIVER 45W x 4 CD-R&RW
2
7
6
8
54
3
1
SWITCHING TO RADIO MODE…………………….…1
Press SOURCE button 1 to select radio mode, the radio mode appears in the display together
with the memory band and frequency.
SELECTING THE FREQUENCY BAND……………..2
At radio mode, press BAND/LOUD button 2 shortly to select the desired band.
The reception band will change in the following order:
FM1 FM2 FM3 MW LW
RADIO TUNING…………………………………………3
Press the TUN/TRK or button 3 shortly to activate automatic seek function. Press for
several seconds until “MANUAL” appears on the display, the manual tuning mode is selected. If
both buttons have not pressed for several seconds, it will revert to seek tuning mode and “AUTO”
appeared on the display.
AUTOMATIC MEMORY
STORING & PROGRAM SCANNING…………………4
- Automatic memory storing
Press P.SCAN/AST button 4 for several seconds, the radio searches for 6 strongest stations
and stores them into the presets of the currently selected band.
- Program scanning
Press P.SCAN/AST button 4 shortly to scan preset station. When the field strength level is
more than the threshold level of stop level, the radio is holding at that preset number for
several seconds with release mute, then searches again.
STORING PRESET STATIONS .................................5
The preset buttons 5 can be used to store 6 stations in each band (FM 1, FM 2, FM 3 and MW,
LW) for convenient access to your favorite stations.
8