• Programming stations ..... 1. Select the desired band, then tune in the station you want to
store in memory.
2. Press and hold one of the preset buttons 5 for more than 2
seconds until the corresponding preset button number appears.
Repeat steps 1. and 2. to program additional stations.
• Quick tuning .................... Select the desired band, then press one of the six preset buttons 5.
LOCAL/DISTANT SELECTION ...........................…..6
Press LOC button 6 to set local or distant stations.
Use local position (LOCAL/LOC appears on the display) for reception of strong station, and
distant position (DX appears on the display) for reception of weaker stations. This function is
effective during AUTO SEEK operation.
MONO/STEREO SELECTION .......................….…...7
Press MONO button 7 to select mono or stereo mode. You can sometimes improve reception of
distant stations by selecting mono operation.
FREQUENCY SCAN OPERATION.......................….8
Press F.SCAN button 8 to set the function to frequency scan mode, which scans stations
and stop for several seconds at each receivable signal. Press F.SCAN button again to stop
scanning.
9
To Next Page
Loading...
