Sanyo GCD 2700 - Name and Functions

ILLUSTRATION OF CD CHANGER MOVEMENT
. This CD changer can accommodate and play up to 5 discs.
a. OPERATION
1.
“ POWER “ ON.
2.
“ FUNCTION “ CD.
3.
“ DISC SELECT “ 1.
4. The sub chassis (27) move$ down.
5. The disc table (82) turns, and the disc 1 table is
brought directly above the mechanism where it
stops.
6, The sub chassis moves up, the disc is chucked, the
turntable (11 -1 ) rotates, the disc’s TOC (table of con-
tents) is read, and the turntable then stops.
If a disc has not been intalled, ” no disc “ appears on
the display.
7. When” DISC SKIP” is pressed, steps 4 to 6 are per-
formed, and operation advances to the next disc num-
ber.
----,.
,.’
-.
b. NAME AND FUNCTIONS OF MAJOR PARTS
1.
Disc table (82)
Disc number detection slits 1 to-5 and a stop ~e~ec-
tion slit are cut into the outside circumference of the
disc table.
These slits are used by th_ephoto coupler to detact
the disc number, deceleration timing and stop poai-
-..
tion,
Also provided on the circumference of the table
area
stabilizing groove and rotation gear.
DISC
..’
DISC Tft3JE GEAR
LCc~3S}loE
I
PINCH LEVER
Jxsc’STOP
K% No.
-12-
i