Sanyo ICR-1000 - EDITING THE RECORDED DATA; Overwrite recording; Insertion recording

[ENGLISH]
GB-15
Operation
switch
EDITING THE RECORDED DATA
Overwrite recording
Note:
Previous recorded material will be
erased.
1. Select the “OVER WRITE” edit
mode. (See Page 10.)
2. Play back the file. (See Page 17.)
3. Slide the operation switch to STOP (or press the CREATE FILE button
to set the pause mode) where you want to start overwriting.
4. Slide the operation switch to DICT. Overwrite recording starts.
Insertion recording
Note:
Previous recorded material will remain.
1. Select the “INSERT” edit mode. (See Page 10.)
2. Play back the file. (See Page 17.)
3. Slide the operation switch to STOP (or press the CREATE FILE button
to set the pause mode) where you want to start insertion.
4. Slide the operation switch to DICT. Insertion recording starts.
Caution:
•Overwrite and Insertion recording start from the stop position on the
file.
• In “END” display, the recording starts from the END position.
• If the INDEX/CANCEL button is pressed in the stop mode, “OVER
WRITE” or “INSERT” edit mode can be changed.
• In “Insertion Recording”, start position may shift somewhat.