128
You cannot erase a file.
Cause The file’s attribute has been set to read-only.
Solution Connect the unit to your PC and then change the attribute of the file or erase it. Or, format
the microSD card.
See “Formatting the internal memory or a microSD card” on page 79.
EH800D or EH800D_SD is not displayed when the unit is connected to your PC.
Cause The unit is not correctly connected to your PC.
Solution Check that the USB extension cable is used to correctly connect the unit to your PC. If
necessary, do the connection again.
See “Connecting your PC” on page 116.
Cause The security function that protects the internal memory is turned on.
Solution Turn off the security function.
See “Turning off the security function” on page 109.
Cause The unit is connected to a Macintosh or PC running Windows 98, 98SE, Me.
Solution Macintosh and PC running Windows 98, 98SE, or Me are not supported.
Cause The power supply from your PC is not enough.
Solution If the unit is connected to your PC via a bus-powered USB hub, try to connect the unit
directly to your PC. You can also use a self-powered type (with AC adapter) USB hub. Or, if
your PC has several USB terminals, try to connect the unit to another USB terminal.
See “Connecting your PC” on page 116.
Cause A network drive is assigned.
Solution If a network drive is assigned, this will conflict with the drive letter of the unit so that
EH800D or EH800D_SD may not be created. To solve the problem, change the assigned
network drive and then connect the unit to your PC again.
Contact your network administrator for information on network drive assignment.
Cause The OS of your PC is Windows 2000.
Solution If your PC is running Windows 2000, it’ll show both the internal memory and the microSD
card as “removable disks”.
To Next Page
Loading...
