GB-26[ENGLISH]
Selecting the action Windows is to take
After connection, the following screen will appear (Windows XP only).
- For Windows98/98SE/ME/2000, this operation is not needed.
The screen shots are of Windows XP.
Adjust your settings to match your PC’s environment.
In this manual, [Take no action] is selected, [Always do the selected action] is
checked, and [OK] is clicked. This completes the connection to the PC.
When connected to the PC, the unit display will be as shown below and none
of the operating buttons will work.
Before disconnecting the unit from the PC, be sure to follow the steps on the
next page. Do not disconnect during data transfer.
Connected to PC Transmitting to/from PC
3) Click
1) Select
2) Check
To Next Page
Loading...
