Sanyo KHS1222 - Adjusting the Airflow Direction; Horizontal Airflow Adjustment; Vertical Airflow Adjustment; Airflow Direction Caution

Zone "A"
for
COOLIWG
NOTE:
Power failure during timer operation
If power failure occurs, the time counted up to that point will become void.
After the power is applied, the timer newly starts counting at the set time.
Adjusting the Airflow Direction
I
I
I
Zone "B”
for
HEATING
A. Horizontal
The horizontal airflow can be adjusted by moving the vertical vane to the
left or right.
B. Vertical
Confirm that the remote control unit has been turned on. Press the SWEEP
button to start the flap moving up and down. If you want to stop the flap
movement and to direct the air in the desired direction, press the SWEEP
button again. In the COOL mode, don't direct the flap down more than 30°
otherwise, condensation may drip on to the floor. Zone "A" is the
recommended flap position for cooling.
0
NOTE
KHS0921 and KHS0922 models:
Since SWEEP button is not provided with above mentioned models, you can
manually move the flap to desired position.
Do not move the flap with your hands.
07 - 346-15
15