Sanyo LCD-32E30A - Menu Operations: Function Settings; Accessing the Function Menu; System Reset and AV Connection; Password Management for Channels

MENU OPERATION
I
Press MENU
button and
the Main Menu will appear.
Press <> buttons
to select
'FUNCTION",
and display
the
"FUNCTION"
menu.
!
Press
r v outtons to select
the desired item.
J
Press OK button
to
confirm
the selec,tion.
The available
functions are
"Reset to defauli',
"AV
Connect',
"Password",
'Parental
Rating",
"Teletext
Mode",
"Channel
LocK,
"EPG'
,
and
"SSU"
Modes separately.
.
Press BACK butlon on
the Remote Control
to cancel operations on
OSD and
return lo normal screen.
. Press illENU button
or wail for about
60
seconds
to exit
menu
operations.
Note:
.
'Password",
and
'Parental
Rating' functions are
only supported foT
ATViDTV input.
.
"Teletext
Mode" mode
is only supported forATV
input.
.
"Channel
Lock",
"EPG"
and
'SSU"
modes are only supported
for DTV input.
@
tf user
requires to reset
10
default
values for the
functions
'Picture", "Sound", "Setup",
"Time/
and
"Funclion",
the
'Reset lo default'
function will return settings
to factory settings.
I
From
'FUNCTION",
press
vbuttons to
select
"Reset to
default'
I
Press OK button to display
the message
"This will do reset to default,
Are
you
sure?"
J
Press OK button
to
start
the
"Reset lo
default"
process.
The TV will
power
off automatically.
^{
Press OK button again
and the Tuning the
TV initial screen
will
appear.
Note: TV channel
list and
password
wont be reset.
@
I
Press ttlENU
button, then
press
< > buttons to select
"FUNCTION'.
I
Press
OK
button and
press
a
Y
buttons to selec't
'AV Connection", lhen
press
OK button.
J
eress
< >
buttons
to select inpul source as
required
'Mdeo 2"
selections
are
"CVBS"
and
"S-Video".
Note:
"
Default setting
of Video 2
is
CVBS
input. You can select
CVBS input or S-Mdeo input
from AV Connection.
.
(CVBS
refers
to
composite
signal.)
@
VMth
Digital
ry
channels and
programs
can be
locked to
prevent
viewing of unsuitable
films and
programs.
These can only accessed
with
a
password.
Default
password
is
"0000."
I
Press MENU button, lhen
press
<> buttons
to
selecl
"FUNCTION'.
I
Press OK button and
press
a
v
buttons
lo
selec{
"Password", then
press
OK button.
J
Enter
your
old
password
using
the number buttons or
press
"0000"
(default password),
then
press
v
button.
{
eress v button and enter
your
new
password,
then
press
v
button
to
confirm again,
then
press
OK button.
Note:
.
lf
you
forget
the
password, press
Green,
Ycllow, OK
and BACK buttons on the remote control.
The
password
will
return to the default setting
'0000".
43