Sanyo LCD-32K30TD - Page 21

21
BASIC OPERATION
2
Picture 3
In the Menu as Picture 1, press ▲, ▼, ◄ or ► button to
select one programme, and press INFO button to enter into
the information as Picture 6, and brief introduction of the
programme will be displayed.
Picture 6
Formula 1 ING Australian Grand Prix
Picture 4
When the TV is ON, if the reserved programme starts in
15sec,itwillstarttocountdownasPicture5.Press◄or►
button to select Yes, and press OK button to switch to the
reservedchannel.Press◄or►button to select No, and
press OK button to stop switching to the reserved channel,
the count time OSD will disappear.If there is no operation,
TV will switch to the reserved channel when the count time is
over.
5
Picture 5
To set Reserve
Picture 2
Formula 1 ING Australian Grand Prix
Press EPG button to display the OSD as Picture 1, press
▲, ▼,◄ or►buttontoselectoneprogramme,thenpress
BLUE button to enter into Reserve menu as Picture 2.
1
Formula 1 ING Australian Grand Prix
Picture 1
In the Reserve menu, press ▲, ▼, ◄ or ► button to set
Programme, Hour, Minute, Mode, Date, Month and Week.
3
After setting Reserve, press OK button to enter into the menu
as Picture 3, and the Reserve information will be saved in the
Schedule LIST in this menu. 5 programmes can be saved at
most.
4
When 5 programmes have been saved in Schedule LIST,
if pressing bule key to set Reserve in Picture 1's menu, the
screen will display "Schedule List Full", shown as Picture 4.
When the Schedule List is full, if Reserve set is still needed,
must enter into the Schedule List as Picture 3, press ▲ or
▼ button to select the programme which has been set as
Reserve, and press RED button to delete.
To view programme's brief introduction
Note:
● The different programmes in same time cannot be set as
Reserves, or the screen will display "Time Overlapped".
● In stand by mode, if the Reserve time is coming, TV will power
on and switch to the reserved channel.
● If the ON TIMER and the Reserve are set as the same time,
Reserve will be operated first.
● If the ON TIMER is earlier than Reserve time, ON TIMER will
be operated first, then operate Reserve when Reserve time is
coming.
● If the Reserve time is earlier than ON TIMER, the ON TIMER
will not be operated after Reserve has been operated.
● After Reserve enactment is executed, If no operation in 2
hours, LCD TV will be off automatically.
● When the time set as Reserve is coming soon, TV will display
the Reserve. When time is up, TV will switch to the channel
set as Reserve automatically.
● All programmes in Schedule List will be removed after Auto
Tuning or reset TV.
● DTV programmes and Radio programmes can be switched by
pressing TV/ Radio button.
LCD-K30TD_(SEI).indd 21 4/22/2009 3:15:06 PM