Sanyo LCD-32XH8T - ADC Adjustments

-12-
Service Adjustments
r ADC ADJUST
1. Enter the Service Mode.
2. Select "ADC ADJUST" by pressing ▲ or ▼ button, then press ENTER button to enter ADC ADJUST
menu.
3. Press ▲ or ▼ button to select "MODE" item, press ◄ or ► button to select RGB, YPbPr(SD) or
YPbPr(HD).
(1). ForFor VGA source, the signal should be 1024x768@60Hz and the pattern should be ANSI Pattern (C).
(2). Enter theEnter the ADC ADJUST menu. PressPress ▲ or ▼ button to select "MODE" item.
(3). Press ◄ or ► button to select RGB.
(4). Press ▲ or ▼ button to select AUTO ADC item, then press ENTER button.
(1). ForFor YPbPr(SD) source, the signal should be 480i and the pattern is 100%, 8 STEP COLOR BAR.
(2). Enter theEnter the ADC ADJUST menu. PressPress ▲ or ▼ button to select "MODE" item.
(3). Press ◄ or ► button to select YPbPr (SD).
(4). Press ▲ or ▼ button to select AUTO ADC item, then press ENTER button.
(1). For YPbPr(HD) source, the signal should be 1920X1080i@60Hz and the pattern is 100%, 8 STEP
COLOR BAR.
(2). Enter theEnter the ADC ADJUST menu. PressPress ▲ or ▼ button to select "MODE" item.
(3). Press ◄ or ► button to select YPbPr (HD).
(4). Press ▲ or ▼ button to select AUTO ADC item, then press ENTER button.
4. Exit the Service Mode.
Wait for about several seconds until AUTO ADC adjust completed. Then press MENU button to exit.
Note: If you want to adjust any item, please consult qualified service personnel.
RGB
YPbPr (SD)
YPbPr (HD)
MODE RGB
ADC ADJUST
R-GAIN 4096
G-GAIN 4096
B-GAIN 4096
RED OFFSET 0
GREEN OFFSET 0
BLUE OFFSET
0
AUTO ADC FAIL