PRODUCT SAFETY NOTICE:
Product safety should be considered when a component
replacement is made in any area of a receiver.
Components indicated by a mark in this circuit dia-
gram show components whose values have special sig-
nificance to product safety. It is particularly recommended
that only parts specified on the part service manual be
used for components replacement pointed out by the
mark.
CIRCUIT DIAGRAM NOTICE:
1. All resistance value are in ohms, K=1,000, M=1,000,000.
2. All resistance rated wattages are 1/6W unless otherwise noted.
3. Excepting electrolytic capacitors, all capacitance values of less than 1are expressed in µ F
and more than 1 are µF.
4. All capacitance rated voltages are 50V unless otherwise noted.
5. All inductance values are in µ H.
6. This circuit diagram covers a basic or representative chassis only. There may be some
components or partial circuit differences between the actual chassis and the circuit diagram.
7. Parts specified with "X" are not installed in this model.
8. Parts specified with "J" are just jumper wires.
Z5HV/Z5HW/Z5HVA/Z5HWA
9. Expression of capacitance and resistance in circuit diagrme.
THE SERVICE PRECAUTION:
The area enclosed by this line ( ) is directly connected with AC mains voltage.
When servicing the area, connect an isolating transformer between TV receiver and AC
line to eliminate hazard of electric shock.
To Next Page
Loading...
