Why is my Sanyo LCD-32XR9DA picture whitish or too bright in dark areas?
If the picture on your Sanyo LCD TV is whitish or too bright in the darkest areas, check if the brightness setting is too high. It's also possible that the brightness grade of your DVD player is set too high.
Why does my Sanyo LCD-32XR9DA LCD TV picture have stripe-shaped bright spots?
If your Sanyo LCD TV picture is interfered with by stripe-shaped bright spots, it could be due to interference from sources like automobiles, trains, high-voltage transmission lines, or neon lamps. Try separating the antenna and power supply line to increase the distance between them. It may also be due to the shielded-layer of signal wire not being properly connected to the connector.
Why is the picture on my Sanyo LCD TV too bright and distorted?
If the picture on your Sanyo LCD TV is too bright and has distortion in the brightest areas, it could be due to a high contrast setting. It's also possible that the output quality of your DVD broadcaster is set too high. The issue might also stem from an improper terminal connection of the video frequency signal.
Why does my Sanyo LCD-32XR9DA have no sound?
If your Sanyo LCD TV has no sound, ensure that the 'mute' setting is not selected and that the volume is not set to the minimum. Also, make sure that earphones are not connected. Finally, check all cable connections to ensure they are secure.
What to do if my Sanyo LCD-32XR9DA says 'XXX in search' with no picture?
If your Sanyo LCD TV shows no picture or signal and displays “XXX in search,” check if the cable is disconnected. Also, verify that the cable is connected to the correct terminal and that the input mode is correctly selected.
How to fix a Sanyo LCD-32XR9DA picture that is out of focus or jumping?
If your Sanyo LCD TV picture is out of focus or jumping, it might be due to a poor signal. Check the electrical connector or antenna for failures. Also, ensure the antenna is properly connected to improve signal reception.
Why is my Sanyo LCD-32XR9DA LCD TV remote control not working?
If your Sanyo LCD TV remote control isn't working, check these potential issues: * Ensure the batteries are correctly installed. * Verify the batteries have power. * Make sure you're within the proper distance and angle from the TV. * Confirm there are no obstructions between the remote and the TV. * Check if strong fluorescent light is interfering with the remote's signal.
To Next Page
General
