EasyManua.ls Logo

Sanyo LCD-40XZ10F - Memorizing the Channels

Sanyo LCD-40XZ10F
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Memorizing the Channels
When you turn on the TV for the first time, you should perform an auto channel search to set up stations on your TV.
Note: Be sure to select the proper input source (ATV/DTV) before operation.
1
Highlight UHF CH item, press 3or4 button to select your desired
channel number.
In Channel menu, press 6or5 to select DTV Manual Tuning
item, then press4or OK to access.
2
If desired digital programs cannot be searched by Auto Tuning, you can
make use of DTV Manual Tuning to search programs manually.
Press OK to begin the manual DTV channel search.
3
At the bottom of the menu screen the DTV Signal strength bar is
displayed. You can make use of it to check how strong your DTV
signal is and whether you need to adjust your antenna or digital cable
input. The higher the signal strength is, the less likely you are to
experience picture degradation.
17
Picture Sound Time Setup Lock Channel
Select
Move
Menu
Return
DTV Manual Tuning
ATV Manual Tuning
Programme Edit
Auto Channel Search
You should perform an auto channel search to search for all channels available and stores them in memory.
1
Press MENU and the main menu screen displays.
And before you start Auto Tuning, it is necessary to select a country firstly.
Then the TV begins memorizing all ATV/DTV channels available in
your area. During the process, you can press MENU to skip the
search, or EXIT to stop.
Auto Tuning
3
Highlight Auto Tuning item, and press 4or OK to access.
2
Press 3or4to select Channel menu, press 6 to access the menu.
4
5
Now a pop-up screen opens. Press 3or4to select a proper
country according to your local area, and then press6or OK to
highlight Start item, and press OK to begin the auto channel
search.(If you want to cancel, press 4to select Cancel item,
and use OK to confirm.)
Channel Tuning
2 %...
TV
ATV
DTV
Radio
Press <Menu> to skip.
Press <Exit> to exit.
:2
Programme(s)
:0
:0
Programme(s)
Programme(s)
78.50MHz
Manual Searching for DTV programs
Picture Sound Time Setup Lock Channel
Select
Move
Menu
Return
ATV Manual Tuning
Programme Edit
Auto Tuning
DTV Manual Tuning
DTV Manual Tuning
Please select channel then
Press OK to search
Bad
Good
Normal
UHF CH
6
Select
Menu
Then all the digital programs available in this channel will be
searched and stored. During the process, you can press MENU or
EXIT to exit the search.
4
Exit
Country Selection
New Zealand
Cancel
Start

Other manuals for Sanyo LCD-40XZ10F

Related product manuals