Fig. 2 Write-protect setup
c) Press menu “Connect”, a dialog box “Device Type is XXX (XXX is corresponding type of SPI
Flash)” will pop up, that is, connection has been successful, please refer to Fig. 3; if connection
is failed, press the first menu “Device” to select SPI Flash type manually, then press menu
“Connect” again;
Fig. 3 Successful connection
d) Press menu “Read”, select the burning file, such as “MERGE.bin”, please refer to Fig. 4;
Fig. 4 Burning file
e) Press menu “Auto”, tick options “All chip”, “program” and relative option switches, please refer
to Fig.5, press key “Run” to begin burning;
To Next Page
Loading...
