Sanyo MAJ-R70 - Changing a Programme; Repeat Playback

EN-14
- The same MP3/WMA fi le can be programm-
ed more than once.
1. Press the MEMO/CLK ADJ button (or the
MEMO/CLOCK button on the remote con-
troller) in the stop mode, “PROG.” appears.
2. Press the
F or B button to select a
MP3/WMA fi le.
3.
Press the MEMO/CLK ADJ button (or the
MEMO/CLOCK button on the remote con
troller).
4. Press steps 2-3 above to programme addi-
tional MP3/WMA fi les.
5. Press the R/ P button (or the USB R/ P button
on the remote controller) to start programme
playback.
- When all programme MP3/WMA fi les have
been played, it stops automatically.
- If you try to enter more than 32 MP3/WMA
fi les, “FULL” appears on the display.
Changing a programme
To change a MP3/WMA file
1. In the stop mode, press the MEMO/CLK
ADJ
button (or the MEMO/CLOCK button
on the remote controller) repeatedly until the
MP3/WMA fi le number to be replaced is dis-
played.
2.
Press the F or B button to select a MP3/
WMA fi le as described above.
3. Press the MEMO/CLOCK button (or the
MEMO/CLOCK button on the remote con-
troller).
To add a new MP3/WMA le to a programme
1. In the stop mode,press the MEMO/CLK
ADJ button (or the MEMO/CLK ADJ button on
the remote controller)
repeatedly until ”p---XX ” fl ash.
Example:
2. Press the F or B button to select a MP-
3/ WMA fi le as described above.
3. Press the MEMO/CLK ADJ button (or the
MEMO/CLOCK button on the remote con-
troller).
Note:
Programmed details cannot be partially deleted
or inserted.
Repeat playback
Please refer to the same description of “MP3/
WMA CD operation” on page 11.
Folder selection
Please refer to the same description of “MP3/
WMA CD operation” on page 11.
Note:
Other various playback operation, please re-
fer to the related description of “AUDIO CD
OPERATION” (page 9-11).
Removing the USB memory device
1. Press the STOPC/BAND (or the STOPC
button on the remote conrtroller) .
2. Remove the USB memory device.
Note:
Do not disconnect the USB memory device dur-
ing playback, recording or advanced operation.If
do, the data may be damaged.
USB