REPLACING THE PRINCIPAL PARTS OF THE CD CHANGER MECHANISM
h. PRECAUTIONS WHEN ASSEMBLING THE CD CHANGER MECHANISM AND CD MECHANISM
(1)
(2)
Does
the CD mechanism move up and down smoothly’?
8
—-
CAM
GEAR (391 )
CD MECHANISM
. Check gap.
LOADING TABLE
+--c=+=-
T
. Is the turntable touching the loading table?
TURN TABLE
When placing the CD on the loading table, make sure the CD is centered.
If there is any tilt
or the like, check the movement of the floating springs (379, 380) of the CD mechanism,
and make
sure the rubber cushions (381 ) are mounted in the specified orientation.
LOADING
TABLE
DISC “
I r----l----
~ k ● Check the gap here
RUBBER
~=
HOLDER (385)
. Confirm that the rubber cushions are
mounted in the correct orientation.
-23-
To Next Page
Loading...
