Sanyo PDG-DSU30 - Disassemble Lamp Driver Module

PDG-DSU30 Condential 2-12
Note: when you assemble the unit must do
actions as below:
1. Use the cable tie to pierce the rst hole of
LVPS for binding the Interlock Switch and
Lamp Driver to LVPS cable
(as blue
square)
.
2. Use clamp to x the Lamp Driver to LVPS
cable
(as orange square)
.
2-18 Disassemble Lamp
Driver
1. Unscrew 1 screw (as red circle) to
disassemble the Lamp Driver Module.