Sanyo PDG-DXL100 - Page 53

PDG-DXL100 Condential
5-5
4. Click "Library".
- Click the "Browse" and navigate to
the directory where you put the DLP
Composer installation les in.
- Click "Library v8.3" folder.
- Click "OK".
5. Click "Communications".
- Select "Serial Port".
- Select the COM Port which you are using.
- Click "Congure".
6. "Serial Port Conguration" picture will
appear on the screen.
- Make sure the settings are as below:
(1) In "Baud Rate" item, select "115200".
(2) In "Data Bits" item, select "8".
(3) In "Stop Bits" item, select "1".
(4) In "Parity" item, select "None".
(5) In "RTS" item, select "Enable".
(6) In "CTS" item, select "Disable".
(7) Key in "6000" into "Read" and "Write"
items of "Timeouts (in milliseconds)".
- Click "OK".
7. Click "OK".