Sanyo PDG-DXL100 - Page 61

PDG-DXL100 Condential
5-13
(11)
5-2-4 8051 Firmware Upgrade
Procedure
1. Execute 8051 FW Program
- Double click "NLINK V1.2" to execute
NLINK program.
Note: - When we execute NLINK program, the
Power LED ashes orange and Fixture LED
ashes red.
2. Choose the right type of MCU
- "MCU Choose" picture will appear on the
screen, select "W79E804".
- Click "OK".
(11) Click "Finish".
- "Manley TPRP1-Protocol Emulator"
will appear on the picture.
- Complete the USB Driver Upgrade
Procedure.
Note: - If "Found New Hardware Wiszard" picture
appear again, repeat step 2 to install USB
Drivier.