Sanyo PDP-42XS1 - Page 25

Setting Picture
22
Freezing picture
Press the FREEZE button to hold on the image on the screen (the video
sources still run). Press again to reactivate the image.
Note:
For the sake of protecting the screen, please do NOT freeze a picture for a long time.
Freeze Picture
Using the Preset Picture Mode
There are three preset picture modes [Vivid, Standard and Mild] and one user-set picture mode [Custom].
Each preset mode has its own picture settings.
[Vivid]: Select for a bright picture.
[Standard]: Select for a normal picture.
[Mild]: Select for a fine/soft picture.
You may directly use the P.MODE button on the remote control to select a desired picture mode .
2
3
4
Press MENU to display the menu main page, if the Video menu page
doesn’t appear, then push ENTER(Up/Down) repeatedly to display
Video menu page .
Press ENTER to access.
1
Push ENTER(Left/Right) to select a desired picture mode.
Press MENU repeatedly to exit.
The Mode item will be highlighted automatically.
1. Mode: Custom
2. Contrast 70
3. Brightness 30
4. Colour 45
5. Hue 0
6. Sharpness 50
7. DNR: Weak
8. Color Temperature: Standard
5. Hue 0
Video
-
+
-
+
-
+
-
+
-
+
Customizing the Picture
Repeat steps 1~2 in [Using the Preset Picture Mode].
1
Push ENTER(Down) repeatedly to select the item you wish to
adjust.
2
Push ENTER(Left/Right) to adjust the value of the item.
3
Press MENU repeatedly to exit.
4
The [Hue] item is for NTSC only.
1. Mode: Custom
3. Brightness 30
4. Colour 45
5. Hue 0
6. Sharpness 50
7. DNR: Weak
8. Color Temperature: Standard
2. Contrast 70
5. Hue 0
Video
-
+
-
+
-
+
-
+
-
+
Reducing Picture Noise
1
Push ENTER(Down) repeatedly to select the DNR item.
2
Push ENTER(Left/Right) to select.
Press MENU repeatedly to exit.
3
4
Sometimes a noisy picture may appear on the screen because of poor
signal. This function helps to enhance the picture quality by reducing the
noise.
Repeat steps 1~2 in [Using the Preset Picture Mode].
1. Mode: Custom
2. Contrast 70
3. Brightness 30
4. Colour 45
5. Hue 0
6. Sharpness 50
8. Color Temperature: Standard
7. DNR: Weak
5. Hue 0
Video
-
+
-
+
-
+
-
+
-
+
Selecting the Preset Color Temperature
1
Push ENTER(Down) repeatedly to select Color Temperature item.
2
Press ENTER(Left/Right) to select.
3
Press MENU repeatedly to exit.
4
1. Mode: Custom
2. Contrast 70
3. Brightness 30
4. Colour 45
5. Hue 0
6. Sharpness 50
7. DNR: Weak
8. Color Temperature: Standard
5. Hue 0
Video
-
+
-
+
-
+
-
+
-
+
Repeat steps 1~2 in [Using the Preset Picture Mode].