Sanyo PLC-WXU700 - Page 46

45
Video Input
Use the Point ◄► buttons to adjust the gamma value to
obtainabetterbalanceofcontrast(from0to15).
Gamma
PressthePoint◄buttontodecreasethesharpnessofthe
image;pressthePoint►buttontoincreasethesharpness
oftheimage(from0to15).
Sharpness
Aninterlacedvideosignalcanbedisplayedinprogressive
mode.Selectoneofthefollowingoptions.
 Off.........Disabled.
 L1..........Foranactivepicture.
 L2..........Forastillpicture.
 Film.......Forwatchingafilm.Withthisfunction,the
projectorreproducespicturesfaithfultothe
originalfilmquality.
Progressive
Noise reduction
Noiseinterferenceonthescreencanbereduced.Select
oneofthefollowingoptionstogetsmootherimages.
 Off.........Disabled.
 L1..........Lowerreduction.
 L2..........Higherreduction.
Note:
 
Noise reductionandProgressivecannotbeselected
when480p,575p,720p,1035ior1080iisselected
(p.42).
Toresettheadjusteddata,selectReset andpressthePoint
►ortheSELECTbutton.Aconfirmationboxappearsand
thenselectYes.Alladjustmentswillreturntotheirprevious
figures.
Reset
Store
Tostoretheadjusteddata,selectStoreandpressthe
SELECTbutton.UsethePoint▲▼buttonstoselectone
fromImages1to4andpresstheSELECTbutton.
AconfirmationboxappearsandthenselectYes.Stored
datacanbecalledupbyselectinganImage (1-4)inthe
ImageModeSelectiononpage43.
Aconfirmationbox
appearsandthen
selectYes
.
Store Menu