Sanyo PLC-WXU700 - Page 52

51
Off
Capture
Capture
Thisfunctionenablesyoutocaptureanimagebeing
projectedtouseitforastarting-updisplayorintervalof
presentations.
Select CaptureandpresstheSELECTbutton.
AconfirmationboxappearsandselectYestocapturethe
projectedimage.
Aftercapturingtheprojectedimage,gototheLogoselect
functionandsetittoUser.Thenthecapturedimagewillbe
displayedthenexttimeyouturnontheprojectororwhen
youpresstheNOSHOWbutton(seepage29).
Tocancelthecapturefunction,selectYesinthe"Quit?"
confirmationbox.
Note:
 •Beforecapturinganimage,select
Standardinthe
ImageSelectMenutocaptureaproperimage(pp.36,
43).
 •AsignalfromacomputercanbecaptureduptoWXGA
(1280x800).Asignalfromvideoequipmentcanbe
capturedexceptfor720p,1035iand1080i.
 •Whencapturingtheimagethathasbeenadjustedby
theKeystonefunction,theadjusteddataisautomatically
resetandtheprojectorcapturesanimagewithout
keystonecorrection.
 •WhenLogo PIN code lockissettoOn,capturecannot
beselected.
 •Whenstartingtocaptureanewimage,thepreviously
storedimageisclearedevenifyoucancelthecapturing.
•Whenthereisnocapturedimageoritisinterrupted
whilecapturinganimage,Usercannotbeselected,you
canonlyswitchbetweenDefaultandOff.
Off
Logo PIN code lock
Thisfunctionpreventsanunauthorizedpersonfrom
changingthescreenlogo.
 Off...........Thescreenlogocanbechangedfreelyfrom
theLogoMenu(p.50).
 On...........Thescreenlogocannotbechangedwithouta
LogoPINcode.
IfyouwanttochangetheLogo PIN code locksetting,
presstheSELECTbuttonandtheLogoPINcodedialog
boxappears.EnteraLogoPINcodebyfollowingthesteps
below.TheinitialLogo PIN codeissetto"4321"atthe
factory.
Logo PIN code lock
Setting