Sanyo PLC-WXU700 - Page 55

54
Setting
Arrow
Pointer
Pointer
Youcanemphasizeapartoftheprojectedimagewiththis
function.UsethePoint▲▼buttonstochooseSpotlight
(Large,MiddleorSmall),Arrow,FingerorDotandpress
theSELECTbutton.See"PointerFunction"onpage14.
Standby mode
Thisfunctionisavailablewhenoperatingtheprojectorvia
network.
 Normal......Supplythepowertothenetworkfunctioneven
afterturningofftheprojector.Youcanturnon/
offtheprojectorvianetwork,modifynetwork
environment,andreceiveane-mailabout
projectorstatuswhiletheprojectorispowered
off.
 Eco............SelectEcowhenyoudonotusetheprojector
vianetwork.Theprojector’snetworkfunction
willstopwhenturningofftheprojector.
Refertotheowner’smanualof“NetworkSet-upand
Operation”.
Note:
•Factorydefaultis
Eco.
•Whenselecting
Normal,thecoolingfansmayberunning
dependingonthetemperatureinsidetheprojectorevenif
theprojectoristurnedoff.