Sanyo PLC-WXU700 - Page 59

58
Remote control
Lamp control
Remote control
Theeightdifferentremotecontrolcodes(Code 1-Code 8)
areassignedtotheprojector;thefactory-set,initialcode
(Code 1)andtheothersevencodes(Code 2toCode 8).
Thesamecodeshouldsetonboththeprojectorandthe
remotecontrol.Forexample,operatingtheprojectorin
Code 7,theremotecontrolcodealsomustbeswitchedto
Code 7.
 To change the code for the projector
 SelectaremotecontrolcodeinthisSettingMenu.
 To change the code for the remote control:
WhileholdingdowntheMENUbutton,presstheIMAGE
buttonthenumberoftimescorrespondingtotheremote
controlcodefortheprojector.See“RemoteControlCode”
onpage13.
Setting
Note:
•Whendifferentcodesaresetontheprojectorandon
theremotecontrol,anyoperationcannotbemade.In
thatcase,switchthecodeontheremotecontroltofit
thecodeontheprojector.
•Ifthebatteriesareremovedfromtheremotecontrolfor
alongperiodoftime,theremotecontrolcodewill
bereset.
Thisfunctionallowsyoutochangebrightnessofthescreen.
Auto........... Thebrightnessaccordingtotheinputsignal
(betweenHighandEcomode).
High........... BrighterthantheNormalmode.
Normal....... Normalbrightness
Eco............ Lowerbrightnessreducesthelamppower
consumptionandextendsthelamplife.
Note:
Lampmodecannotbechangedforawhileafterturning
ontheprojector.Lampneedssometimetostabilize
afterthepoweristurnedon.Storedlampmodewillbe
activeafterthelampisstabilized.