Sanyo PLC-XF46N - Page 48

- 48 -
D
D
C
C
A
A
B
B
OPTICAL FILTER UNIT 2
OPTICAL FILTER UNIT 3
OPTICAL FILTER UNIT 4
OPTICAL FILTER UNIT 1
E
Optical filter
Optical filter
Optical filter
Optical filter
Holder
Holder
Holder
Holder
Plate
Plate
Plate
Plate
F
G
H
Printed marker
comes this surface
side.
Printed marker
comes this surface
side.
Printed marker
comes this
surface side.
Printed marker
comes this
surface side.
17-2
Optical Filter units removal and disassemblies.
1. Remove 2 screws-A and remove the Optical filter unit1.
2. Remove screw-E, remove the plate and remove the Optical filter upward. (See Fig.17-2a)
3. Remove 2 screws-B and remove the Optical filter unit2.
4. Remove screw-F, remove the plate and remove the Optical filter upward. (See Fig.17-2b)
5. Remove 2 screws-C and remove the Optical filter unit3.
6. Remove screw-G, remove the plate and remove the Optical filter upward. (See Fig.17-2c)
7. Remove 2 screws-D and remove the Optical filter unit4.
8. Remove screw-H, remove the plate and remove the Optical filter upward. (See Fig.17-2d)
(See Fig.17-2, 17-2a, 17-2b, 17-2c, 17-2d)
Note : Do not touch optical filters surface directly with hand.
Each mirror uses different characteristic optical filter glasses. Mark the mirrors as they are removed from
the optical unit so that they may be reassembled in the location and direction from which they were
removed.
Fig.17-2
Fig.17-2a
Fig.17-2b
Fig.17-2d
Fig.17-2c
Optical Unit Disassemblies