Sanyo PLC-XF47 - Page 28

- 28 -
B
B
A
A
Note;
Mark the Fans as they are removed from the holder so that they may be reassembled in the same location
from which they were removed. Be careful of the attachment direction of Fans.
See arrow mark in a figure.
Ballast units may be reassembled in the same location and direction from which they were removed. Be
careful of the attached direction of Ballast units.
Lamp Ballast Units 1-2
1. Remove 2 screws-A, remove the Fan(FN908) and FAN Guard.
2. Remove Lamp Ballast unit 1 and remove the Spacer.
(Unhook the Fixer Clamp and remove the Lamp Ballast unit .)
3. Remove Lamp Ballast unit 2 and Spacer.
(Unhook the Fixer Clamp and remove the Lamp Ballast unit .)
Lamp Ballast Units 3-4
4. Remove 2 screws-B, remove the Fan(FN907) and FAN Guard.
5. Remove Lamp Ballast unit 3 and Spacer.
(Unhook the Fixer Clamp and remove the Lamp Ballast unit .)
6. Remove Lamp Ballast unit 4 and remove the Spacer.
(Unhook the Fixer Clamp and remove the Lamp Ballast unit .)
5-5
Lamp Ballast Units disassemblies.
Lamp Ballast unit 1-2
Lamp Ballast unit 3-4
Mechanical disassemblies
Holder
Holder
Holder
Holder
Holder
Holder
The direction of a wind.
(FN907)
FN907
FAN Guard
Ballast 4
Ballast 3
Spacer
Spacer
Spacer
Spacer
Ballast 2
Ballast 1
The direction of a wind.
(FN908)
FAN Guard
FN908