Sanyo PLC-XF47 - Page 29

- 29 -
C
C
C
D
D
D
D
E
E
A
A
A
A
B
B
B
B
5-6
PFC Unit 3-4 and Power Unit removal.
PFC Unit 3-4 removal.
1. Remove 4 screws-A and remove the PFC 3-4 Unit.
2. Remove 4 screws-B and remove the Fan (FN914).
3. Remove 3 screws-C and remove the Holder FN.
4. Remove 4 screws-D and remove the PFC 3-4 Board.
5. Remove 2 screws-E and remove the AC net Board.
Note;
Mark the Fans as they are removed from the holder so that they may be reassembled in the same location from which they
were removed. Be careful of the attached direction of Fan.
See arrow mark in a figure.
PWB board may be reassembled in the same location and direction from which they were removed. Be careful of the
attached direction of PWB board.
Mechanical disassemblies
PFC 3-4 unit
AC net Board
Holder PFC
PFC 3-4 Board
Holder FAN
The direction of a wind.
(FN908)
FN914