- 66 -- 66 -
Troubleshooting
● No Power
Check the indicators for the projector condition.
Indicators
Projector Condition
LAMP
red
READY
green
WARNING
TEMP.
red
LAMP
REPLACE
orange
The projector is off. (The main switch is OFF position or the AC power cord is
unplugged.)
The projector is in stand-by mode. Press the ON/STAND-BY button to turn
on the projector.
The projector is operating normally.
The projector is preparing for stand-by or the projection lamp is being
cooled down. The projector cannot be turned on until cooling is completed
and the READY indicator lights green.
The projector is in the Power management mode.
The projector is operating normally.
• • • on
• • • off
• • • blinking at the normal rate
(approx. 1 second ON, 1
second OFF)
• • • dim
• • • blinking slow (approx.
2 seconds ON, 2 seconds
OFF)
• • • blinking fast
(appro x 0.5 seconds ON, 0.5
seconds OFF)
✽
✽
✽
✽
✽
When the projection lamp reaches its end of life, the LAMP REPLACE indicator lights orange. When
this lights orange, replace the projection lamp a new one promptly. Reset the lamp counter after
replacing the lamp.
●
LED indication and error condition
To Next Page
Loading...
